Orcon/Slingshot NF18AC/NF4V ADSL

We do not provide support or assistance with this router.

1. Connect your router to Phone Jack or DSL port in your wall via a  Phone/DSL cable, This should go in the grey DSL port in the Router and   should plug either directly into the wall or into the DSL port in a   small filter device which will plug into the wall. Ensure nothing is plugged into the blue WAN

2. Log on to your Netcomm router

Browse to the login page http://192.168.1.1

Username: admin
Password: (this can be found on the sticker on the bottom of the device) this will be different from the wifi password.

3. Click "Basic Setup" on the left.

4. Select "ADSL" and click "Next"

5. Select "PPP Over Ethernet" and click "Next"

6. Select "Enter the username and password shown below" and click "Finish" If you see a confirmation screen following this click "Apply/Save".

Username: user@stuff-fibre.co.nz
Password: stuff123
VPI: 0
VCI: 100

7. Your router is now correctly configured.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request